The 17.5mm carburettor. The carburettor has a 38mm feed at the air filter and uses 6mm main nozzles.
When adjusting the nozzle size and mixing screw, it is recommended that the engine is warm. Therefore, you should at least drive a trip of approx. 5 minutes.
The carburettor is supplied without a gooseneck, we recommend that you purchase a loose gooseneck with the desired bend, see related products below. The carburettor is not made with gooseneck threads, but the said goosenecks fit down into the top of the carburettor where you can use the rubber cap to hold the gooseneck.
Specifications:
On a PGO, petrol must be connected to the golden spigot, the slanted one on the choke side and the one in the sump are both overflows and the horizontal one must be blinded off.
NOTE: Adjustment of the throttle cable may be necessary. This carburettor is for use with automatic chokes with 7mm choke pistons, this is not supplied with the carburettor.
Specifications | |
---|---|
Carburetor size | 17.5mm |
Main nozzle size | # 90 |
Fitment, air filter | 38mm |
Main nozzle type | DellOrto 6mm |
Idle nozzle size | # 35 |
Idle nozzle type | DellOrto PHVA 4mm |